OE style single offset bushing 23160 series also available.

NOTE: Excessive spindle turning effort or poor steering returnability MAY be the result of not following the proper tightening sequence or worn/bent ball joints.

ALWAYS CHECK FOR SUSPENSION CLEARANCE.

Modifying any suspension component may change other part clearances and cause binding or interferences.  After installing any of Ingalls' products, the suspension must be checked for binds or interference between all components, other arms and the chassis. Be sure that all control arms, struts and steering ends move freely through the full movement of the suspension (springs may need to be removed to fully check component travel). Installing any Ingalls product on a modified vehicle (lowered or raised) from the original factory design requires a detailed check of all suspension components and their movements. Ingalls recommends that a trained technician install and adjust all products.